Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Problem
When I push the
steam control to
the turbo steam
position, the
steam control
jumps back.
Only part of
the light ring is
lighted in safety
auto-off mode.
The base is not
lighted up when
I place the iron
on it.
Possible cause
This is normal.
The turbo steam is
designed as this.
This is normal. This
is intended to save
energy in safety auto-
off mode.
The iron is not
connected to the base
properly.
ENGLISH
Solution
Keep holding the steam
control in the turbo
steam position while
using turbo steam. For
other steam settings, this
is not necessary.
N/A
Take out the iron and
put it back to the base
again.
13
Publicité
Table des Matières
