Perel CSOLMF Mode D'emploi page 6

Installation
1.
2.
3.
4.
5.
Working Mode – Sensor Mode
1.
2.
V. 01 – 02/04/2019
CSOLMF
Use the card to measure the position of the holes correctly.
Drill two holes.
Insert a nylon plug in each hole.
Insert a screw in the lower nylon plug and tighten slightly.
Insert the lower notch of the lamp onto the screw.
Straighten the lamp and fasten the upper screw.
Press the mode button to adjust the working mode.
When battery capacity is higher than 30 %, the sensor
mode automatically switches on when a motion has been
detected. It switches to weak brightness for 20 seconds
after the last motion detection.
When battery capacity is lower than 30 %, the sensor
mode automatically switches on when a motion has been
detected. It switches off 20 seconds after the last motion
detection.
6 ©Velleman nv