Installing The Product - Beko HISW 63222 SO Manuel D'utilisation

3 Installation

3.6 Installing the product

1. Remove burners, burner caps and grills on the
hob from the product.
2. Turning the hob upside down, place it on a flat
surface.
3. In order to avoid the foreign substances and
liquids penetrate between the hob and the
counter, please apply the putty supplied in the
package on the contours of the lower housing
of the hob but make sure that the putty does
not overlap.
4. Fill the corners by forming bends at the corners
as illustrated in the figure. Form as much bend
as required to fill the gap in the corners.
C
Make sure that the skirting sections
on the lower housing of the hob are
filled with putty.
5. Turning the hob again, align and place it on the
counter.
6. You can secure your hob to the counter by using
the clamp and the screws supplied.
1. Hob
2. Putty
3. Installation clamp
4. Counter
Thickness of the counter must be at least 40 mm.
Built-In Hob / User Manual
When installing the hob onto a cab-
inet, a shelf must be installed in
C
order to separate the cabinet from
the hob as illustrated in the above
figure. This is not required when in-
stalling onto a builtunder oven.
For example, if it is possible to touch the bottom
of the product since it is installed onto a drawer,
this section must be covered with a wooden plate.
min. 25 mm
For counters with a thickness of 40-50 mm, install
the clamps as shown below.
You must leave a ventilation opening on the re-
maining part in order to provide ventilation at the
lower part of the hob. In addition to being neces-
sary for component temperatures, this process
is also compulsory for the TC burner to take in air
from the bottom. It can be "100 cm² at least".
17 / EN