Care And Maintenance; Troubleshooting - Jensen MSR2010 Guide D'installation Et D'operation

MSR2010

CARE AND MAINTENANCE

• Keep the product dry. If it does get wet, wipe it dry immediately. Liquids might contain
minerals that can corrode the electronic circuits.
• Keep the product away from dust and dirt, which can cause premature wear of parts.
• Handle the product gently and carefully. Dropping it can damage circuit boards and
cases, and can cause the product to work improperly.
• Wipe the product with a dampened cloth occasionally to keep it looking new. Do not use
harsh chemicals, cleaning solvents, or strong detergents to clean the product.
• Use and store the product only in normal temperature environments. High temperature
can shorten the life of electronic devices, damage batteries, and distort or melt plastic
parts.
Ignition
The most common source of noise in reception is the ignition system. This is a result of the
radio being placed close to the ignition system (engine). This type of noise can be easily
detected because it will vary in intensity of pitch with the speed of the engine.
Usually, the ignition noise can be suppressed considerably by using a radio suppression type
high voltage ignition wire and suppressor resistor in the ignition system. (Most vessels employ
this wire and resistor but it may be necessary to check them for correct operation.) Another
method of suppression is the use of additional noise suppressors. These can be obtained from
most electronic supply shops.
Interference
Radio reception in a moving environment is very different from reception in a stationary
environment (home). It is very important to understand the difference.
AM reception will deteriorate when passing under a bridge or when passing under high voltage
lines. Although AM is subject to environmental noise, it has the ability to received at great
distance. This is because broadcasting signals follow the curvature of the earth and are
reflected back by the upper atmosphere.

TROUBLESHOOTING

Symptom
No power The vessel's power is not
on
The fuse is blown
No sound Volume too low or Mute is
on
Fader is set incorrectly
Wiring is not properly con-
nected
Unit unresponsive Control panel not properly
installed
The built-in microcomputer
is not operating properly
Cannot tune to radio sta- The antenna cable is not
tion, auto-seek does not connected.
work
The signals are too weak.
9
Cause Solution
If the power supply is properly
connected to the vessel's acces-
sory terminal, switch the ignition
key to "ACC".
Replace the fuse.
Adjust volume to audible level.
Press AUDIO button to access
menu and adjust FADER setting.
Check wiring connections.
Reinstall control panel.
Set RESUME in menu.
Insert the antenna cable firmly.
Select a station manually.