Installation; Basic Requirements; Assembly; Connections - dental X PURITY Manuel D'utilisation

Dental X

2. INSTALLATION

2.1

BASIC REQUIREMENTS

Check that the voltage of your installation matches the value indicated by the label on the power supply
module, and that the socket to which the unit will be plugged has a rating of at least 1A.
The manufacturer is not responsible for damage to people or things caused by
inadequate electrical installations.
2.2

ASSEMBLY

Remove the sterilizer's tank cover and store it for possible future
use.
Lay PURITY on the sterilizer, checking that the three guides fit in the
tank without damaging it and that the float is free to move.
WARNING The float is fragile, handle with care.
2.3

CONNECTIONS

Connect the supplied PURITY draining pipe (the pipe with a shorter
section) to the central connector on the PURITY back panel; tighten the fixing ring nut. Connect the other
end of the pipe to a drain outlet.
Note: The quantity of drain water is minimal, therefore the pipe can also be let to drain freely in a basin or
be directed to the house water drain.
Elbow fitting
WARNING The draining pipe is under pressure, and possible noise should be generated if
connected directly into a drain; install a discharge aerator.
Local regulation could require the installation of drain separating element.
Use the supplied feeding pipe; connect the elbow fitting end to the connector on the left of the PURITY
back panel and the other end to the tap water outlet.
4
230Vac 50Hz
120Vac 60Hz
Water feeding outlet. ¾'
PURITY draining
Sterilizer draining
PURITY