Hold Function - LaserLiner MultiMeter XP Mode D'emploi

Backlight
21
Long-press the button (4) to switch the backlighting on and off. The backlighting switches on auto-
matically in dark conditions.

Hold function

22
The „Hold" function enables you to keep the current measured value on the display.
Press the „HOLD" (4) button to activate and deactivate the function.
Replacing the fuse
23
To replace the fuse, first disconnect the test prods from their voltage source and then from the device.
Open the housing and replace the fuse with one of the same type and specification (10A / 1000V or
800mA / 1000V). Close the housing and carefully screw the meter back together.
Information on maintenance and care
Clean all components with a damp cloth and do not use cleaning agents, scouring agents and solvents.
Remove the battery(ies) before storing for longer periods. Store the device in a clean and dry place.
Calibration
The meter needs to be calibrated and tested on a regular basis to ensure it produces accurate
measurement results. We recommend carrying out calibration once a year.
Data transfer
This device has digital connectivity which allows wireless data transfer to mobile devices such
as smart phones or tablets with a wireless interface.
The system prerequisites for a digital connection are specified at
http://laserliner.com/info?an=ble
This device can generate a wireless connection to devices which are compatible with the wireless
standard IEEE 802.15.4. The wireless standard IEEE 802.15.4 is a transfer protocol for Wireless Personal Area
Networks (WPAN). The range is set to a maximum distance of 10 m from the terminal device and greatly
depends on the ambient conditions such as the thickness and composition of walls, sources of interference
as well as the transmit / receive properties of the terminal device.
26
EN
800