Fritel CO 2980 Mode D'emploi page 22

3) Program hot water
1. Make sure the Hot Water function is not turned on (If it is: Press I/O (ON/OFF) to turn of the hot water
function.)
2. To set the start time:
a.
b.
3. Once the desired start time is displayed: let go of the PROG button and the actual time is displayed.
4. Press PROG to make the appliance start on the programmed time. The PROG button will light up green
when the program is set. To cancel the program, press the PROG again.
Empty the hot water reservoir:
- Pull the plug from the socket and let the appliance cool down completely.
- The hot water reservoir needs emptying if the appliance is stored away or if it hasn't been used for more than
a week.
- Put the appliance above a drain and pull the hot water cap in order for the water to be able to pour out.
- Once empty you can put the cap back.
6. CLEANING AND MAINTENANCE OF THE APPLIANCE AND ITS ACCESSORIES
1. Put 500ml in the water reservoir en add 10 caps of WIGO descaler.
2. Press I/O (ON/OFF). After 30 seconds, press I/O (ON/OFF) once more and wait 30 minutes. Press I/O (ON/OFF).
3. Press I/O (ON/OFF) once more when it is finished.
4. Let the program run 2 – 3 times with clean water. Let the appliance cool down between the programs.
5. Pull the plug out of the socket.
6. Only clean the housing of the appliance with a moist cloth.
NEVER immerge the appliance in water or any other liquid.
Press PROG (program) of the command panel of Hot Water
(time on display starts to flash)
Once the time flashes: Press simultaneously on PROG and on 00:-- or --:00 till the desired
start time is displayed.
22