Ebode RMML Guide Utilisateur page 7

Receiver - Micro Appliance Modules Ref : RMML
Do not connect more lights as the total permitted amount of wattage allows.
1. CAUTION: Shut off power to the circuit in the electrical panel.
2. With the aid of a screwdriver press on the top of the terminal board and
insert the cables (for the light fixture see diagram 1, for the power socket see
diagram 2). Then verify the connections by pulling lightly on the wires.
3. Pull out the antenna as far as you can for better reception.
PROGRAMMING
The Micro Transmitter commands must be recognized in order to add the Micro
Receiver to a different installation from the original or to one with interference
from a nearby system.
1. Proceed to make a "Reset". Press down and hold the button in the (PROG)
opening with a paper clip until the LED lights up GREEN, then release it. The LED
should flash YELLOW: the Micro Receiver now has no code.
2. With the paper clip, press down briefly in the (PROG) opening. The LED will
flash GREEN and wait for a command from a Micro Transmitter or remote control
switch.
3. Press one of the buttons on the Micro Transmitter or the remote control switch:
the Micro Receiver LED will stop blinking, confirming it has received the command.
The programming is done!
REMARKS
The RMML Micro Receiver will remember as many Micro-Transmitters and remote
control switches as necessary.
VERIFICATION
Verify On/Off switch operation.
You must wait about a second between each On / Off command.
When changing the battery, the registered code will be retained by the Micro
Transmitter.
Troubleshooting -
please check FAQ and technical support on
www.ebodeelectronics.eu
July 2009 page 7 RMML