Sleep Function; Other Important Information; Specifications - Magnat MC 1 Mode D'emploi

SLEEP FUNCTION

This function enables you to set a time after which the device will switch off automatically
and change to the standby mode.
• Press the SLEEP button on the remote control. The following appears in the display:
• Press the SLEEP button again and the following will be displayed:
90 min. Sleep mode
• You can reduce the switch-off time in 10-minute intervals by using the SLEEP button. The
sleep mode is deactivated at SLEEP 00.
• After the time has been set the display automatically reverts back to its previous status.
However, confirmation that the sleep mode is active is visible in the display.

OTHER IMPORTANT INFORMATION

Headphones
• You can connect headphones with a 3.5 mm stereo jack to the socket located on the front
of the MC 1.
• Before doing this set the volume to VOL 00.
• The sound from the speakers is automatically disconnected when headphones are
inserted.
• Please note that listening to music at high volume via headphones can cause irreparable
damage to your hearing!
Line in (front panel)
• This is used for connecting an audio source with a 3.5 mm stereo jack.
The other analogue connections on the rear of the MC 1 are designed for RCA cables.
If you should have any further queries, please refer to the operating instructions for the
respective device.
Phono input
The MC 1 has a high quality phono preamplifier with RIAA equalisation. Only record players
with a magnetic system (MM) or a moving coil system with high level output (high output
MC) may be connected here.
Most of these devices have an additional earth wire. Please connect this to the rear of the
MC 1 using the screw (10) in order to minimise the degree of humming.
GB

SPECIFICATIONS

Amplifier
Power output:
Rated power 20 Hz – 20 kHz, THD < 1.0%, 4 ohm
20 Hz – 20 kHz, THD < 1.0%, 8 ohm
Pulse power 1 kHz, 4 ohm
Frequency response:
5 Hz – 100 kHz (-3.0 dB)
20 Hz – 20 kHz (-0.5 dB)
Phono 20 Hz – 20 kHz (-1.0 dB)
Signal to noise ratio:
CD/Aux/Line/Tape 95 dB
Phono 85 dB
Input sensitivity/impedance:
AUX/Line/Tape 250 mV/33 kOhm
Phono
Equalisation:
Bass ±10 dB/100 Hz
Treble ±10 dB/ 10 kHz
FM Tuner
Frequency response: 87.5 – 108 MHz
Signal to noise ratio:
Mono 75 dB
Stereo 70 dB
Harmonic distortion:
Mono <0.25%
Stereo <0.50%
AM Tuner
Frequency response: 531-1602 MHz
Signal to noise ratio: 40 dB
Miscellaneous
Dimensions (wxhxd): 360 x 110 x 400 mm
Weight: 8.9 kg
Electricity consumption::
Max 200 W
Standby 1.4 W
18
5 mV/47 kOhm
Subject to technical change.
2 x 80 w
2 x 60 w
2 x 150 w