EINHELL PROFI Silver Line PS-SB 1100E Mode D'emploi page 13

Anleitung PS-SB 1100 E_SPK1
wherever possible.
6.2 Switching the tool on and off (Figure 3)
First fit a suitable drill bit into the tool (see pre-
vious section).
Connect the mains plug to a suitable socket.
Position the drill in the position you wish to drill.
Only then should you switch on the machine:
Press and hold the ON/OFF switch (5)
-> The drill will start
Release the ON/OFF switch (5)
-> The drill will stop
Continuous operation: If you wish to use the
hammer drill permanently, press the locking but-
ton (4) after pressing and holding the ON/OFF
switch (5).
Deactivate continuous operation: Press the
ON/OFF switch (5) in fully; this will release the
locking button (4).
6.3 Setting the speed (Figure 3)
You can infinitely vary the speed whilst using the
tool.
Select the correct speed: The most suitable
speed depends on the workpiece, the type of use
and the drill bit used. Low pressure on the
ON/OFF switch (5): Low speed (suitable for small
screws and soft materials)
Higher pressure on the ON/OFF switch (5):
Higher speed (suitable for large/long screws and
hard materials)
Tip – Start drilling holes at low speed. Then
increase the speed in stages.
Benefits:
- The drill bit is easier to control when starting the
hole and will not slide away.
- You avoid drilling messy holes (for example in
tiles).
6.4 Preselecting the speed (Figure 3)
The speed setting ring (6) enables you to define
the maximum speed. The ON/OFF switch (5) can
only be pressed to the defined maximum speed
setting.
Set the speed using the setting ring (6) and the
arrow on the ON/OFF switch (5).
Do not attempt to make this setting whilst the drill
is in use.
18.08.2005 14:11 Uhr Seite 13
6.5 Selecting the direction: Clockwise/Counter
clockwise (Figure 3)
Switch the direction of the hammer drill using the
Clockwise/Counter-clockwise switch (7)
Direction Switch position
Clockwise/Forwards R
Counter-clockwise/Reverse L
Do not attempt to make this setting whilst the drill
is in use.
6.6 Defining the speed range (Figure 4)
The speed selector switch (8) enables you to
work within a specific speed range.
Speed range Switch position
Low torque,
high speed 1
High torque,
low speed 2
Do not attempt to make this setting whilst the drill
is in use.
6.7 Drill / Hammer drill selector switch (Fig. 5)
Use the Drill/Hammer drill selector switch (3) to
set whether you wish to drill or hammer drill.
Operating Switch posi- Application
mode tion
Drill Drill symbol Wood, metal,
plastic
Hammer drill Hammer Concrete, rock,
symbol masonry
6.8 Tips for working with your hammer drill
1. Drilling concrete and masonry
Switch the Drill/Hammer drill selector switch (3)
to the hammer symbol position.
Always use carbide drill bits and a high speed
setting for drilling into masonry and concrete.
2. Drilling steel
Switch the Drill/Hammer drill selector switch (3)
to the drill symbol position.
Always use HSS drill bits for drilling into steel
(HSS: high speed steel) together with a low tor-
que setting.
GB
13