Making Toast - Graef TO-61 Notice D'utilisation

EN
nigung abkühlen.
∙Benutzen Sie keine aggressiven
oder scheuernden Reinigungsmit-
tel und keine Lösungsmittel.
∙Kratzen Sie hartnäckige Ver-
schmutzungen nicht mit harten
Gegenständen ab.
∙Achten Sie darauf, dass kene Flüs-
sigkeit in das Geräteinnere ge-
langt.
4
Unpacking
To unpack the unit, proceed as be-
low:
∙Take the unit out of the carton.
∙Remove all pieces of the packing.
∙Remove any possibly extant labels
on the unit (do not remove the rat-
ing plate).
Requirements for the in-
stallation location
For safe and flawless operation of
the unit, the place of location must
meet these prerequisites:
∙The unit must be set up on a firm,
flat, level, non-slip and heat resist-
ant base that has sufficient load
bearing capacity.
∙Select the place of location so that
children cannot reach the hot sur-
faces of the unit.
∙The unit is not intended for instal-
lation in a wall or a built-in cup-
board.
∙Do not set up the unit in a hot,
wet or moist environment.
∙The electric socket must be readily
accessible so that the power cord
can be easily unplugged.
∙The unit emits a great amount of
heat towards the top. Never place
the unit on a cupboard, under cur-
tains or next to combustible ma-
terials.
∙Never place the unit near paper,
fabric or similar materials. The
bread can burn.
Before the first use
When using for the first time, op-
erate the unit 1 - 2 times at the
middle level without any toast as it
is possible that a slight odour will
develop due to possible dust rem-
nants on the heating spirals.

Making toast

Connect the unit to the mains sup-
ply:
∙Put the toasting goods into the
slot.
∙Select the desired degree of
browning (1 light - 6 very dark)
∙Press the lift button down until it
latches.
Extra-lift
The extra-lift eases removing the
toasted goods.
Lift the lift button and take out the
toasted goods.
Bread slice centring
It does not matter if you want to
toast large or small slices of bread,
or thick or thin ones, the bread slice
centring device always positions
your toasted goods at the right
place and ensures uniform brown-
ing on both sides.
Attachment for buns
The attachment for buns can also
be used as a warmer for your fresh-
ly toasted bread. Simply place the
toasted goods on the bun attach-
ment.
Defrost feature
Important
It is not necessary to adjust the
control knob as the defrost time is
preset
∙Put the frozen toasting goods into
the slot.
∙Press the * button.
∙Press the lift button down until it
latches.
Stop feature
∙Press the stop button.
∙The toasting process is interrupted.
Bun warm-up feature
To warm up buns, proceed as be-
low:
∙Place the bun attachment on the
unit.
∙Place the buns on the bun attach-
ment.
∙Set the browning degree control
to between steps 2 and 3.
∙Press the lift button down until it
latches.
∙When the lift button returns to the
top, turn the buns over once and
repeat the process.
Caution
The attachment for buns is hot du-
ring toasting; do not touch it.