Before The First Use; Unpacking; Requirements For The Installation Location; Making Toast - Graef TO102 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
of the unit.

Before the first use

When using for the first time, operate the unit
1 - 2 times at the middle level without any
toast as it is possible that a slight odour will
develop due to possible dust remnants on the
heating spirals.

Unpacking

To unpack the unit, proceed as below:
Take the unit out of the carton.
Remove all pieces of the packing.
Remove any possibly extant labels on the
unit (do not remove the rating plate).

Requirements for the installation location

For safe and flawless operation of the unit, the
place of location must meet these prerequi-
sites:
The unit must be set up on a firm, flat, level,
non-slip and heat resistant base that has suf-
ficient load bearing capacity.
Select the place of location so that children
cannot reach the hot surfaces of the unit.
The unit is not intended for installation in a
wall or a built-in cupboard.
Do not set up the unit in a hot, wet or moist
environment.
The electric socket must be readily acces-
sible so that the power cord can be easily
unplugged.
The unit emits a great amount of heat to-
wards the top. Never place the unit on a cup-
board, under curtains or next to combustible
materials.
Never place the unit near paper, fabric or si-
milar materials. The bread can burn.

Making toast

Connect the unit to the mains supply:
Put the toasting goods into the slot.
Select the desired degree of browning (1
light - 6 very dark)
Press the lift button down until it latches.

Extra-lift

The extra-lift eases removing the toasted
goods.
Lift the lift button and take out the toasted
DE
EN
FR
ES
IT
NL
Рус
Укр
11

Publicité

Table des Matières
loading

Table des Matières