GROUNDING INSTRUCTIONS
This appliance must be grounded. This oven is equipped with a cord having a
grounding wire with a grounding plug. It must be plugged into a wall receptacle that
is properly installed and grounded. In the event of an electrical short circuit,
grounding reduces risk of electric shock by providing an escape wire for the electric
current. It is recommended that a separate circuit serving only the oven be provided.
Using a high voltage is dangerous and may result in a fire or other accident causing
oven damage.
WARNING Improper use of the grounding plug can result in a risk of electric shock.
Note:
If you have any questions about the grounding or electrical instructions, consult
1.
a qualified electrician or service person.
Neither the manufacturer nor the dealer can accept any liability for damage to the
2.
oven or personal injury resulting from failure to observe the electrical connection
procedures.
The wires in this cable main are colored in accordance with the
following code: Green and Yellow = EARTH
Blue = NEUTRAL
Brown = LIVE
MICROWAVE COOKING PRINCIPLES
Arrange food carefully. Place thickest areas towards outside of dish.
1.
Watch cooking time. Cook for the shortest amount of time indicated and add
2.
more as needed. Food severely overcooked can smoke or ignite.
Cover foods while cooking. Covers prevent spattering and help foods to cook evenly.
3.
Turn foods over once during microwaving to speed cooking of such foods as
4.
chicken and hamburgers. Large items like roasts must be turned over at least
once.
Rearrange foods such as meatballs halfway through cooking both from top to
5.
bottom and from the center of the dish to the outside.
BEFORE YOU CALL FOR SERVICE
If the oven fails to operate:
Check to ensure that the oven is plugged in securely. If it is not, remove the
1.
plug from the outlet, wait 10 seconds, and plug it in again securely.
Check for a blown circuit fuse or a tripped main circuit breaker. If these seem to
2.
be operating properly, test the outlet with another appliance.
Check to ensure that the control panel is programmed correctly and the timer is set.
3.