Personalisation; Setting The Temperature; Setting The Drying Cycle; Functions - Indesit EWDC 7145 Mode D'emploi

Personalisation

Setting the temperature

Turn the TEMPERATURE knob to set the wash temperature (see Table of wash cycles).
The temperature may be lowered, or even set to a cold wash
ting a temperature which is higher than the maximum value set for each wash cycle.
!
Exception: if the 2 programme is selected, the temperature can be increased up to a value of 60°C.

Setting the drying cycle

Turn the DRYING knob to select the desired drying
option. There are two options:
A - Based on time: From 40 minutes to 180.
B - Based on the desired laundry dryness level:
Iron dry : suitable for clothes which will need ironing
afterwards. the remaining dampness softens creases,
making them easier to remove.
Hanger dry : ideal for clothes which do not need to
be dried fully.
Cupboard dry : suitable for laundry which can be put
back in a cupboard without being ironed. If your laundry load to be washed and dried is much greater than the maximum stated
load (see adjacent table), perform the wash cycle, and when the cycle is complete, divide the garments into groups and put some
of them back in the drum. At this point, follow the instructions provided for a "Drying only" cycle. Repeat this procedure for the
remainder of the load.
Drying only
Use the cycle selector knob to select a drying cycle (15-16) in accordance with the type of fabric. The desired drying level or
time may also be set using the DRYING knob.

Functions

The various wash functions available with this washer-dryer will help to achieve the desired results, every time.
To activate the functions:
1. Press the button corresponding to the desired function;
2. the function is enabled when the corresponding indicator light is illuminated.
Note:
- If the selected function is not compatible with the programmed wash cycle, the corresponding indicator light will flash and
the function will not be activated.
- If the selected function is not compatible with another function which has been selected previously, the indicator light corre-
sponding to the first function selected will flash and only the second function will be activated; the indicator light corresponding
to the enabled option will remain lit.
Enable the
adjust all wash parameters through a longer lasting cycle. The option always leaves the temperature unchanged, while the spin
cycle is automatically brought back to maximum levels. The user can set the spin cycle back to the desired value at any time.
Easy iron
By selecting this function, the wash and spin cycles will be modified in order to reduce the formation of creases. At the end of
the cycle the Washer-dryer will perform slow rotations of the drum; the indicator lights for the EASY IRON and START/PAUSE
options will flash (the first one green, the second orange) and the "FIN" indicator light turns on. To end the cycle, press the
START/PAUSE button or the EASY IRON button.
Note: If you also want to run the drying cycle, this option is enabled only if combined with level "Iron dry"
1/2 Spin
Press this button to reduce the spin speed
Delay timer
This timer delays the start time of the wash cycle by up to 9 hours. Press the button repeatedly until the indicator light correspond-
ing to the desired delay time switches on. The fifth time the button is pressed, the function will be disabled.
N.B. Once the START/PAUSE button has been pressed, the delay time can only be modified by decreasing it until launching
the set programme.
option for very dirty items, where compatible. Press this option to let the cycle automatically re-
. The washer-dryer will automatically prevent you from selec-
Table of Drying times
(guideline values)
Fabric
Load type
type
Clothing of diffe-
Cotton rent sizes, Terry
towels
Synthe-
Sheets, Shirts, Py-
jamas, socks, etc.
tics
Cupboard Henger
Max.
load (kg)
dry dry
5 250 210
3 180 130
.
GB
Iron
dry
190
115
21