Features - RIDGID R84082 Manuel D'utilisation

FEATURES

PRODUCT SPECIFICATIONS
Operating Temperature:
Normal .......................................................... 32˚F−104˚F
Frequency Ranges:
AM Band ................................................520−1710 (kHz)
FM Band .............................................87.5−107.9 (MHz)
Audio Output ................... 10 Watts nominal into 4 Ω (Ohm)
Power Requirements:
120 V AC, 1 Amp, through cord or 18 V DC through
RIDGID slide-mount batteries
2 AAA (1.5 V DC) batteries for memory/clock backup
1 CR2032 button cell battery for remote control
External Jacks:
Antenna Connector .................. For single-wire antenna
iPod Connector ............ 30-pin iPod docking connector
Input Jack ...................................... 3.5 mm (Inside door)
Size .................................... 20 in. x 12 in. x 11 in. (LxHxW)
Weight ..................................................................... 13.9 lb.
KNOW YOUR JOB-SITE RADIO
See Figures 1 - 2, pages 15 - 16.
The safe use of this product requires an understanding of
the information on the product and in this operator's manual
as well as a knowledge of the project you are attempting.
Before use of this product, familiarize yourself with all op-
erating features and safety rules.
AC CORD
Your job-site radio can be plugged into an AC power
source.
CORD WRAP
The feet of the radio provide a convenient cord wrap that
can be used during transport.
FOLD-DOWN ROTATABLE FLEXIBLE
ANTENNA
The antenna rotates to help improve reception. The flexible
design prevents damage from bending. It folds down and
out of the way when not in use.
FCC COMPLIANCE
NOTE: This equipment has been tested and found to comply
Internal Speakers
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not oc-
cur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment on and off, the
user is encouraged to try to correct the interference by one
or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and
receiver.
 Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
 Consult the dealer or an experienced radio/TV technician
for help.
iPod COMPARTMENT
The iPod compartment, located in the drop-down door on
the front of the radio, helps protect your iPod from jobsite
debris. Inside the compartment, there is a 30-pin iPod dock-
ing connector. To charge or play, connect your iPod to the
connector and place the radio in iPod mode.
LCD DISPLAY
The LCD display is clear and visible in all lighting
conditions.
NOTE: The illustrations of the LCD display shown in this
manual are only examples of the frequencies you may see
on your radio and are not the exact frequencies that you
may choose to listen to.
PROTECTIVE FRAME
The radio is mounted with shock absorbers inside a pro-
tective frame to help protect your radio while in use on the
job site. The design of the frame also allows the radio to be
placed on its feet or on either of its sides during play or for
storage.
7 - English
WARNING:
Changes or modifications to this unit not expressly
approved by the party responsible for compliance
could void the user's authority to operate the
equipment.