Paul Mitchell Neuro Light Guide D'utilisation page 6

• Keep the air openings free of lint, hair, etc.
• Never use while sleeping
• Never drop or insert any object into any opening or hose.
• Do not use an extension cord with this appliance.
• Avoid multiple cables to a plug.
SAVE THESE INSTRUCTIONS.
• Do not direct hot air toward eyes or other heat-sensitive areas.
• Attachments may be hot during use. Allow them to cool before handling.
• Do not place the dryer on any surface while it is operating.
• While using the appliance, keep your hair away from the air inlets.
• Do not operate with a voltage converter.
THE ALCI PLUG
This appliance is equipped with an ALCI (appliance leakage current interrupter)
safety device specifically engineered for safety. The ALCI plug is intended to
interrupt its load circuit when there is an electrical fault to the appliance. It is
for household use and may be plugged into a standard AC electrical outlet
(ordinary household current). The ALCI safety device in this unit is built into the
plug. This device will make it inoperable under some abnormal conditions, such
as accidental immersion in water. If the appliance is immersed in water, do not
attempt to reset the ALCI safety device.
The ALCI safety device is equipped with a test button so that its operation can
be checked.
TO TEST
1. Press the Reset button on the ALCI safety device.
2. Plug your blow-dryer into an AC outlet, then press the Test button.
3. The Reset button will pop out. This verifies the safety device is operating
properly. If the Reset button does not pop out, do not use the unit. Return it
immediately for service.
4. Press the Reset button to reactivate the ALCI safety device. Your blow-dryer
is ready for use. Repeat this procedure every time you use the blow-dryer to
confirm that the safety device is operating properly.
SPECIAL ATTENTION
If the unit detects an electrical shock hazard, it will immediately shut off. To
restore power, press the Reset button on the ALCI safety device to reactivate
the circuit.
Test the ALCI plug before each use as noted:
1. Press Test button.
2. Reset button will pop up. If it doesn't, do not use appliance.
3. Press Reset button to test for power.
If the ALCI plug is damaged, it must be replaced by the manufacturer or its
service agent in order to avoid a hazard.
MAINTENANCE
Daily Maintenance: For the safe use of the dryer, check the following daily:
• Check the cord and surface of the cord. Never use if any parts are cracked,
split, torn or damaged.
• Check the plug and never use if it is cracked, split or damaged.
• Check the plug pins and never use if transformed or damaged.
• Check the controller and do not use if cracked, split, broken or damaged.
• When not in use, clean and dry the entire dryer and store in a cool, dry place.
When ready to use, follow the directions for daily maintenance.
Routine Cleaning: To keep dryer clean, unplug the dryer from the power
source. Once the dryer is cool, check to see if filter is dirty. Clean filter often for
optimal performance and longevity.
WARNING: Do not wipe the dryer with thinner, benzene, gasoline, lamp oil, and
other solvents or chemicals, as that may cause accidents or malfunction and
may damage the dryer and void the warranty.