Paul Mitchell Neuro Light Guide D'utilisation page 3

OPeratiNG
instruCtions
On / Off Increase Decrease
Button Button
Button
Temperature/
Speed Bar
FILTER
SmartSense
Filter Reset Button
SmartSense
"Clean Filter" Light
press the power button to turn on the
blow-dryer. The temperature/speed bar, logo and
"Clean Filter" will light up.
use buttons to:
• Increase the temperature and airflow
• Decrease the temperature and airflow
press the Cool shot button to release cool air.
Release the cool shot button to return to heating.
smartsense "Clean Filter" light
After 30 hours of use, the SmartSense "Clean Filter"
light will begin to blink to alert you to wash and clean
the filter (thoroughly wash filter with warm water and
air dry). Press the Reset button for approximately 5
seconds to reset the filter button and reset for another
30 hours. The "Clean Filter" light will stop blinking
once reset.
press the power button to turn off the hair dryer.