Pushtracker Battery Charging; Maintenance; Inspection; Cleaning - max mobility PushTracker Mode D'emploi

max mobility
7

PushTracker Battery Charging

Plug the provided wall adapter into a wall outlet and plug the USB cable [standard
USB type A] plug into the wall adapter [this can also be done prior to plugging
into the wall]. Then plug the USB connector [standard USB type micro-B] into the
small port on the side of the PushTracker module making sure the it is powered off.
The charging LED indicator light on the PushTracker will be red while the unit is
charging, and will turn green once the battery is fully charged. The PushTracker can
be charged using any standard USB [type A] port found on a computer, car charger
with USB plug, etc. and any type A to micro-B cable. The estimated charge time for a
full recharge of the PushTracker battery is approximately 1.5 hours.
Always store and charge the PushTracker in a cool, dry area. Hot and damp
environments can damage or short the unit, requiring a costly replacement.
Make sure the charging receptacles are completely dry before plugging in the
charger, for this can cause a spark or short.
Also, never attempt to use the PushTracker while charging.
Do not shower or bathe with the PushTracker on.
Do not throw away the PushTracker. Please properly
dispose of the battery by recycling at the end of its life or
send it back to Max Mobility.

5. Maintenance

Inspection

Always inspect the PushTracker for missing parts / damage prior to each use. Cease
use and contact Max Mobility or your mobility equipment dealer if you notice any of
the following:
• Broken or cracked plastic
• Missing or loose screws
• Charging port damage
• Broken buckle or ripped bands
• Damaged Display

Cleaning

Cleaning of the PushTracker can be done by wiping all of the parts down with a
damp wash rag. This should be done as needed.
®