Preparing For Use; Using The Appliance - Philips HP6523 Mode D'emploi

Preparing for use

Charging
Charging the epilator takes approximately 1 hour. When the epilator is fully
charged, it has a cordless operating time of up to 30 minutes.
1 Switch off the appliance before you charge it.
2 Insert the appliance plug into the socket in the bottom of the
appliance (1) and put the adapter in the wall socket (2).
, The charging light lashes white to indicate that the appliance
is charging.
, When the battery is fully charged, the charging light lights up white
continuously for 20 minutes and then goes out.
Battery low or empty
When the battery is almost empty, the charging light starts to lash
-
red. When this happens, the battery still contains enough energy for
a few minutes of epilating.
When the battery is completely empty, the charging light lights up red
-
continuously. To charge the epilator, see section 'Charging' above.

Using the appliance

Clean the epilating head and charge the appliance fully before you use the
appliance for the irst time.
Note: You cannot use the appliance while it is connected to the mains.
Epilating tips
Wet: If you are new to epilation, we advise you to start epilating on
-
wet skin, as water relaxes the skin and makes epilation less painful and
more gentle. The appliance is waterproof and can be safely used in the
shower or bathtub.
Tip: If you want, you can use your regular shower gel or foam.
ENGLISH
7