Setting The Run-On Time; Setting The Extraction Power; Other Settings; Switching On The Cleaning Function - DURAVIT DuraSystem WD5003 Notice D'utilisation

Setting the run-on time

You can set the run-on time of the odour extraction via your remote control
(see table 4).
> Press the "Fan run-on time" preselection button on your remote control.
The left status LED on the control panel lights up blue. You now have 4 seconds to
change the settings step by step. If you select "0", the odour extraction is stopped as
soon as you leave the toilet.
> Press the "Plus" setting button if you want to increase the setting.
> Press the "Minus" setting button if you want to decrease the setting.
The right status LED flashes blue each time you press the button. The setting is
increased/decreased by the corresponding steps.

Setting the extraction power

You can set the extraction power of the odour extraction via your remote control
(see table 4).
> Press the "Fan speed" preselection button on your remote control.
The left status LED on the control panel lights up blue. You now have 4 seconds to
change the setting step by step.
> Press the "Plus" setting button if you want to increase the setting.
> Press the "Minus" setting button if you want to decrease the setting.
The right status LED flashes blue each time you press the button. The setting is
increased/decreased by the corresponding steps.
Odour extraction
Run-on time
Extraction power
Table 4: Odour extraction

6.3 Other settings

Switching on the cleaning function

You can lock the buttons on the actuator plate for 2 minutes to prevent a flush and the
odour extraction being triggered during cleaning.
46
Factory setting
manual
1 min.
3
Setting range
On/Off
0 min., 1 min., 3 min.
1 to 6