PROEM MDC-2F4 Manuel Utilisateur page 4

Monitor MDC-2F4
English
09 - Restore to default
Select User Setup item on main menu page to enter setup page,then select Next Page item
and press MENU button to enter User Setup 2 page,select Restore to default item and press
MENU button,a message will be asked to confirm the restore operation.Press Menu button
again ,All settings will be restored to default.(Note that the restore to default operation will
not change the time setting and the datas.)
User Setup (2)
Ring Volume ...
Night Ring Volume ...
Restore to default ...
Last Page
Exit OK Select Item
10 - Unlock parameter setting
Main Menu User Setup (1)
Monitor ... Door Station Call Tone ...
Manual Monitor Intercom Call Tone ...
DoorBell Tone ...
Intercom
Clock ...
User Setup
Close Next Page
Exit
About OK Select Item
2. Select Next Page item to en-
1. Select User Setup item
ter next page.
on main menu page.
Code Number:[0000]
[0010]:Remove remote
[8000]:Master 0
[8004]:Guard unit
[8006]:Panel on as slaver called [8007]:Panel off
[8008]:MM/DD/YYYY
[8010]:Unlock mode 0
[8012]:12-Hour system
[8014]:Unlock2 on
[8021]~[8029]:Unlock time set 1~9s
5. Input 4 digits number accord-
ing to the following information.
Use▲ / ▼ button to increase/
decrease the value, use
button to select the digit.
- 6 -
Restore to Default
Are you sure to
Restore all to default?
Cancel OK
User Setup (2)
Ring Volume ...
Night Ring Volume ...
Restore to default ...
Last Page
OK Select Item Exit OK Select Item
3. Select Restore to
default item.
Restore to Default
[0011]:Add remote
[8001]~[8003]:Slaver 1~3
Are you sure to
[8005]:Not guard unit
[8009]:DD/MM/YYYY Restore all to default?
[8011]:Unlock mode 1
[8013]:24-Hour system
[8015] :Unlock2 off
Cancel OK
4. Press UNLOCK button
and hold for 2 s.
/
Note:
1. 8015 is set the unlock2 off, you can only release one
lock. 8014 is used to set the unlock2 on,when 2 locks
are installed,this item must set on.you can release two
locks.at this mode, press UNLOCK button,two un-
lock icons will be showed. Use▲ /▼ button to select
the item you want, and press UNLOCK or MENU
button to release the corresponding door,select
item to exit.
2. Restore to default operation will not chang the parameters setting.
11 - Screen and volume adjustment
During monitoring or talking, press MENU Button,the
Use ▲ / ▼ Button to select the adjustment item; use
the value.
1. The first item is Scene mode selection: Total 4
screen modes can be selected in sequence:
and Whenever you modify
mal, User, Soft Bright.
Brightness or colour, Scene item will be set to
mode automatically.
2. The Brightness and Colour item is for the image
quality setting, adjust the value to get the best im-
age you like.
3. The Ring Volume and Talk Volume items are ring
tone and talking volume adjustment.
4. Note that all the modifications will be done immediately after the operation. Press
"MENU" button to quit the adjust page.
1
2
ADJUST MENU will be displayed.
/ Button to decrease / increase
Nor-
Scene Brightly
Bright 6
Color 6
User
Talk Volume 2
Select Camera ...
Exit Dec/Inc
Select Item
- 7 -