Features; Assembly; Operation - Ryobi P785 Manuel D'utilisation

PRODUCT SPECIFICATIONS
LED ............................................................. 3 per light head
Light Output ...........................................Over 1500 lumens
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance. In Mexico, please call 01-800-843-1111.
WARNING:
Do not direct the light beam at persons or animals and
do not stare into the light beam yourself (not even from a
distance). Staring into the light beam may result in serious
injury or vision loss.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this tool for the purpose listed below:
 To illuminate distant objects and areas requiring additional
light

FEATURES

Cord Length Between Heads ......................................10 ft.
Power Source ................. 18 Volt DC/120 V, AC only, 60 Hz

ASSEMBLY

WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.

OPERATION

NOTICE:
This product is designed to be powered by either a
Ryobi One+
™
power (AC mode). Either power source can be used by
installing an approved battery pack or power cord into
the product as described in this manual.
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 9.
 Insert the battery pack into the base as shown.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured before
beginning operation.
 Depress the latches to remove the battery pack.
For complete charging instructions, refer to the Operator's
Manuals for your battery pack and charger models.
WARNING:
Always remove battery pack or unplug extension cord
from your product when you are assembling parts,
making adjustments, cleaning, or when not in use.
Removing battery pack or unplugging extension cord
will prevent accidental starting that could cause serious
personal injury.
6 – English
18V battery pack (DC mode) or by electric
™