Remote Use - Harvia Xenio CX004WIFI Instructions D'installation Et D'utilisation

4. REMOTE USE

Note! The sauna room and surroundings of the heater must always be checked
before the heater is switched on again or it is switched on with the remote-control
system.
Remote use with the safety switch: The heater can be turned on remotely if the safety switch circuit is
closed. If the circuit is open, "SAFE" is displayed and the heater will not start.
Preset time: If the control unit is on preset delay time, it cannot be controlled with a remote switch. After
the preset delay has passed and the heater is turned on, it can be turned off with a remote switch.
Dehumidifying: When the heater is turned off remotely and dehumidifying is enabled, dehumidifying
starts and cannot be stopped remotely. When dehumidifying is in progress and a safety switch is used, the
heater can be turned on remotely. If a door switch is used, the heater cannot be remotely started, as the
remote use mode must be re-activated by pressing and holding the control unit's heater button for three
seconds.
Power saving mode: If no buttons are pressed in 30 minutes, power saving mode
is activated. Only the heater button (and "rc on", if remote use mode is active) is lit.
Pause time: When the heater is switched off, status message rESt. appears on the
control panel display. This feature prevents the heater from turning on automatically
during a timed start or weekly clock if it has been less than 6 hours since the
heater was last turned off.
FOTA (Firmware Over the Air)
The Xenio WiFi control panel has a feature that automatically downloads the latest
firmware to the control panel.
EN
17