BH SHIATSU S100 Instructions De Montage Et Utilisation page 35

G. Frequently Asked Questions.-
MAKING SURE SHUT OFF ELECTRICITY BEFORE YOU DOING IT.
If the supply cord id damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
G.1 The control panel does not work.
Problem
1. The power indicator isn't on
2. The soft keys do not work
G.2 The light doesn't work.
1. The bulb filament isburned out.
G.3 The heater tube does not heat.
Warning: Only qualified person can replace or repair the heater.
Problems
1 Part of the heater
does warm up
2 The entire room
does not heat
3 Bench heater
does not heat
- Replacing the main fuse.-
- The location of the fuse holder is shown by the arrow on the top roof panel, Fig.18.
H. Maintenance.-
H.1 Clean the sauna room with a soft wet cloth. NEVER use petrol, alcohol, benzene or any other such
chemical to clean the unit.
H.2 In hospital or public use areas the sauna can be detoxified with ultrasonic equipment.
The fuse is broken or the
sauna is not plugged in
Unplug sauna, wait a minute or plug back into power source.
Problem
Explanation
The heater is defective
Part of the heater is not connected
well or burned out
The relay is damaged
The control panel isdamaged
The plug is
correctly
It is not connected tightly into the
Outlet on the back panel
Explanation
Change the bulb (≤15 watt)
Replace with a new heater
Connect them tightly
Replace the relay
Replace the control panel
not plugged in Re-plug it
Connected tightly No Duch
Construction used.
Fig.18
35
Solution
Change the fuse or the plug
in the sauna
Solution
Solution