Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
6. Installing Tools
NOTE:
When using tools such as bull points,
cutters, etc., make sure to use the genuine
parts designated by our company.
(1) Clean the shank portion of the tool.
(2) As shown in Fig. 2, pull grip (A) in the
direction of
, and insert the tool into a
A
hole of the front cap in a state where it is
further turned in the direction of
(3) Adjust the groove position while turning
the tool, and furthermore insert it until it
hits the end of the hole.
(4) Return grip (A) to its original position, pull
the tool and make sure it is locked
completely. (Fig. 3)
7. Deciding Working Position of Tool
The tool can be turned every 30 degrees
and can be fixed at the position of 12 steps.
(1) As shown in Fig. 4, if the grip (A) is turned
in the direction of
grip (B) is turned 60 degrees in the direction
of
, the blade angle can be changed
A
freely to any desired position.
(2) As shown in Fig. 5, if grip (B) is turned 60
degrees in the direction of
part of the tool automatically turns 30
degrees. If this action is repeated, the blade
angle of the tool can be changed by every
30 degrees.
(3) Release grip (B) and turn the tool, and
make sure that it is locked completely.
8. Removing Tool
As shown in Fig. 2, pull grip (A), and pull
out the tool in a state where it is further
turned in the direction of
14
.
B
in a state where the
B
, the holding
A
.
B
Grip (A)
Tool
Shank
A
Front Cap
Fig. 2
Fig. 3
Grip (A)
A
B
Grip (B)
Fig. 4
Grip (B)
Fig. 5
B
A
Publicité
Table des Matières
