Connection Of The Endoscope Camera - VOLTCRAFT BS-350XIPSD Mode D'emploi

c) Connection of the endoscope camera
Now connect the enclosed endoscope camera to the BS-350XIPSD.
• If you have switched on the device, switch it off again at first
(see chapter 8 d).
• Push the plug of the camera C3 into the connection A1 of the endoscope
(see arrow).
The proper orientation can be told by the guide pin in the plug. When the
endoscope is display-up, the pin must also still point up.
When pushing on, ensure that you do not bend or break off any pins.
• Turn the closure of the camera plug counter-clockwise (see arrow) until
it is tightened hand-tight.
The camera plug must no longer move then.
To remove the camera again, switch off the BS-350XIPSD first and screw open the
metal closure again (turn -clockwise). Then remove the camera.
38