Product Set-Up - D-Link NetDefend DFL-160 Guide D'installation

PRODUCT
SET-UP
CD SET-UP WIZARD
ADVANCED SET-UP (ACCESS VIA IP ADDRESS)
To configure the DFL-160 manually (without the set-up CD) first connect an Ethernet cable from
your Cable/DSL modem to the firewall's WAN port. Connect an Ethernet cable from the firewall's
LAN1 port to your computer or to your network hub or switch. Connect the power cable to the
DFL-160.
Open a browser window and enter the following IP address in the browser address field:
DFL-160
SET-UP WIZARD CD
The CD contains all of the instructions required to set-up DFL-160.
INSERT CD
Insert the CD into the CD drive of your computer. The set-up
wizard should start automatically. Make sure that your internet
connection is active. (Do not plug in DFL-160 yet)
SET-UP WIZARD
Follow the steps within the wizard to complete the set-up of
DFL-160.
IP ADDRESS: http://192.168.10.1
USERNAME: admin
PASSWORD: admin
5