Publicité
Les langues disponibles
Les langues disponibles
Caution! For compliance with EN 50131-6 Grade 2, it is mandatory to wire the wall removal and cover
opening contact.
Adjusting the trigger height of the contact is done via a screw (supplied).
Installing the 5 output card with fuses into the AXS2 allows:
-
to protect by fuse the 5 outputs (S1 to S5)
to isolate the 5 outputs (S1 to S5)
-
or
5 output card with fuses can be mounted on a C34 box. Refer to the instructions supplied with 5 output card
with fuses.
Wiring / Connections
-
connections with the equipment switched off
(upstream circuit breaker open and battery
fuse removed).
the maximum cross-section of wires
-
permitted on terminals S1, S2, S3, S4, S5 is
2.5 mm² (minimum cross 0,3 mm²)
the fuse rating of each output (S1 to S5) is
-
limited to 4A / standard fuse (5 x 20 mm).
the maximum current for all 5 fused outputs is
-
16A.
-
commissioning and operation instructions can be downloaded from www.slat.com
no equipment may be returned without prior issuance of an RMA number.
-
-
for additional technical assistance, or to request and RMA number,
contact the SLAT hotline on + 33 (0) 4 78 66 63 70
-
product warranty: 3 years, see our general sales terms
Option – 5 output card with fuses SLAT
Commissioning and Technical Support
7
Publicité
