Wood's Venezia G Mode D'emploi page 14

Troubles
1. UNIT DOES NOT START WHEN
PRESSING ON/OFF BUTTON
2. Not cool enough
3. Noisy
4. E0 Code
5. E3 Code
6. E2 /E4 Code
WARNING
Specific information regarding appliances with R 290 refrigerant gas.
Thoroughly read all of the warnings.
•
Possible Causes
- Water full indicator lamp blinks, and
water tank is full.
- Room temperature is higher than the
setting temperature. (Electric heating
mode)
- Room temperature is lower than the
setting temperature. (Cooling mode)
- The doors or windows are not closed.
- There are heat sources inside the
room.
- Exhaust air hose is not connected or
blocked.
- Temperature setting is too high.
- Air inlet is blocked.
- The ground is not level or not flat
enough
- The sound comes from the flowing of
the refrigerant inside
conditioner
Room temperature sensor failed
Pipe temperature sensor failed
Water tank full
Suggested Remedies
Empty the water tank.
Reset the temperature
Reset the temperature
Make sure all the windows and doors
are closed.
Remove the heat sources if possible
Connect or clean the exhaust air hose.
Reset the temperature
Clean the air inlet.
Place the unit on a flat, level ground
if possible
It is normal.
the air
Replace room temperature sensor
(the unit can also work without
replacement.)
Replace pipe temperature sensor (the
unit can
replacement.)
Please empty the water tank.
also work without