Accessories - Onda OVS Notice D'utilisation

6.6 Accessories

The following accessories can be purchased on request:
For the correct installation of these accessories refer to the proper operating instructions.
6.7 Installation of the coalescing filters for two-stage Oil Separator
1- Make sure to have M10 screws as in the sketch below
2- Put a M 10 bolt at a distance of 25 mm from the round side of the screw
3- Put the screw into the filter
4-Put a washer and a bolt into the screw's leaning part from the filter, then tighten
strongly
5- Look at the lower part of the filter and place the screw in the centre
6- Put an O-RING in the fitting of the filter
- Level Electrical gauge
- Thermostat
Electric heater complete with socket
-
- Coalescing filter for two-stage oil separator
14