Assembly Instructions; Mounting - Deltafox DG-ELB 3014 Traduction De La Notice D'utilisation Originale

• Do not overload your device.
Work only within the indicated
range of performance. Do not
employ any low power ma-
chines for heavy work. Do not
use your device for purposes
for which it has not been de-
signed.
• Before each use, check the
power supply lead and the ex-
tension cable for damage and
ageing. Do not use the equip-
ment if the cable is damaged or
worn.

Assembly instructions

Remove the power plug before all
work on the device. Employ only
original parts. Danger of injury.

Mounting

Before putting the device into
operation, the blower / suc-
tion tube must be completely
mounted and screwed tight and
the collection bag and carrying
strap must be attached.
Mounting the casing handle
1. Slide the casing handle (9) over
the handle retainers on the up-
per and rear motor casing (11).
2. Check that it is firmly in place.
3. Screw the casing handle (9)
with two short screws (22).
Mounting the blower/suction
tube
4. Plug the two sections of the
blower/suction tube (2a+2b)
into each other and screw them
together (3).
5. Plug the upper blower/suction
tube (2b) into the blowing/suc-
tion hole on the motor casing
(10).
6. Fix the blower/suction tube us-
ing the fastening screw (3).
Installing the guide rollers
7. Push the holder (1) over the
lower blower/suction tube (2a)
and screw it tight.
8. Attach the guide rollers (19) on
to the holder (1) on the right and
left. These lock into place.
Mounting the additional handle
9. Pull the additional handle (4)
apart slightly and slide it onto
the guide on the appliance
housing (10).
10. Screw the additional handle (4)
using the knurled screw (23)
provided.
Mount carrying strap:
11. Open the closure of the attach-
ment eye (6).
12. Hook the carrying strap (5) into
the mounting eye (6) on the mo-
tor casing (11). Shut the closure
on the carrying strap.
Fitting the collection bag
13. First fasten the lower loop of
the collection bag (16) on the
lower fixing point (18)
14. Place the retainer frame (15) onto
the opening on the motor casing
(10) such that the click-in fasten-
ers audibly click into place.
15. Fasten the upper loop of the
collection bag (16) on the upper
fixing point (12) of the motor
housing (10).
GB
27