Silverline 329863 Mode D'emploi page 12

GB
Troubleshooting
Problem
Router will not operate
Router runs or cuts slowly
Makes an unusual sound
Excessive vibration
Heavy sparking occurs inside motor
housing
12
Possible cause
No supply of power
Brushes worn or sticking
Switch is faulty
Motor components faulty or short circuited
Blunt or damaged cutter
Speed setting too low
Motor is overloaded
Mechanical obstruction
Armature has shorted sections
Incorrectly fitted or loose router bit
Bent or damaged router bit
Brushes not moving freely
Armature short circuited or open circuited
Commutator dirty
Solution
Check that power is available at source
Replace carbon brushes
Have the tool repaired by an authorised Silverline service centre
Have the tool repaired by an authorised Silverline service centre
Resharpen or replace cutter
Increase speed setting
Reduce pushing force on router
Have the tool serviced by an authorised Silverline service centre
Have the tool serviced by an authorised Silverline service centre
Refit or tighten router bit
Replace router bit
Have carbon brushes checked and replaced by an authorised Silverline service
centre
Have the tool serviced by an authorised Silverline service centre
Have the tool serviced by an authorised Silverline service centre