Battery Replacement - Nemaxx WL 10 Mode D'emploi

Version: 10.0
20.09.2016
Instruction
The photoelectric wireless online smoke alarm WL10 can be connected each other and
become a system. Its communication is very easy just through a LEARN button. In a
learnable wireless online smoke alarm system, if one smoke alarm detects the smoke
and sounds, others will sound together. In this case, the users will know the fire danger in
advance and take action.
The product is used in the family house and the non-smoking places.
Testing
1. Insert 1pc 9V battery and 3pcs 1.5V battery (according to the picture).
2. The RED alarming LED flashes in about every 40s in working condition
(according to the picture).
3. Depress the TEST button for several seconds, the red alarming LED and the LEARN
(red and green) LED flashes, then the smoke alarm sounds.
It shows that the smoke alarm is in working
9V lithium
battery
1,5V battery
installation hint
3x 1,5V
battery

Battery replacement

1. Turn the alarm body counter clockwise and take off the cover.
2. Take out the batteries. Place the new batteries to the power connector.
3. Put the top cover back on and turn clockwise to close cover tight.
4. Always test the smoke alarm by using the test button after you replace or have taken out
the batteries.
CAUTION!!!
Danger of explosion if the lithium battery is incorrectly replaced.
Please only replace with the same type of battery.
9V lithium battery
installation hint
EN
Alarming
LED (red)
Test button
2
Doc. No. : WL10-0001
Revision No.: 1.0
Horn
Learn LED
(red or green)
Learn button