MAC Audio ÜBERKRAFT 2.16 Mode D'emploi page 4

DEAR CUSTOMER,
We congratulate you on acquiring this MAC
AUDIO Car Stereo Product.
Please read these instructions carefully
so as to ensure optimum and disturbance-
free functioning of the appliance. Technical
modifications reserved.
POSITIONING AND SECURING THE SPEAKER
SYSTEM (FIG. 1)
Use the mounting positions provided in your
vehicle. If the speakers do not fit, they can be
placed in the rear window shelf.
Fig. 1
(1) Depth
(2) Driver diameter
Fig. 1A
(1) Use mounting ring to mark position of
speaker opening and fastening holes
(2) Cut out opening and drill holes
Make sure that the subwoofer is secured in
such a way that it cannot slip or slide. Use the
screws provided for this purpose. Damage
resulting from sudden changes in speed (e.g.
hard braking) is not covered under the terms
of our guarantee.
CONNECTING TO THE RADIO / AMPLIFIER
(FIG. 2)
The speaker system should preferably be
connected to an external power amplifier.
This can provide the required electrical power
and create corresponding dynamic reserves.
The relevant instructions also contain the
customized connection diagram for the
operation of a speaker system.
Should you not have a power amplifier, the
speakers can also be connected directly to
the radio. The relevant operating instructions
also contain the connection diagram for this
situation.
Please note that only limited dynamic
reserves will be available in this case.
Excessively low outputs combined with high
distortions can destroy your speakers.
TWEETER LEVEL SWITCH (FIG. 2)
This switch can be used to raise or lower the
tweeter level by 3 dB. The best position can be
determined by listening and trying it out.
TWEETER PROTECTION
There is a protective element integrated into
the crossover of your ÜBERKRAFT 2.16 tweeter,
which has high impedance in cases of overload
and reduces the current flowing through the
tweeter. If the tweeter is deactivated, please
turn down the volume and wait for a moment.
After cooling down, the tweeter will re-activate
and is ready for operation again.
INSTALLING THE TWEETER (FIG. 3)
INSTALLING THE GRILLE (FIG. 4)
4
POLYSWITCH