Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18
1
1 Detector tip
1

Inserting batteries

Open the battery compartment and insert batteries according
to the symbols. Be sure to pay attention to polarity
Before using the device, you should always test it on a main
!
circuit you know to be operational within the specified voltage
range.
2
Localising electrical voltages
Position the detector tip in the
area to be tested (e.g. cable,
socket. etc.).
To determine the L/N conductors, then check the neutral conductor,
no signal should appear here.
!
For safety, check all three phase conductors (L1, L2, L3)
for the presence of voltage!
!
Replace the batteries if the output is weak or reduced.
To make sure check the PE connection, the installation is not safe
if a signal appears here. Observe the technical safety regulations
for working on electrical systems, especially:
1. Safely isolating from power supply
2. Securing to prevent system being switched on again
3. Checking zero potential, two-pole
4. Earthing and short-circuiting
5. Securing and covering adjacent live components
08
EN
2 Pocket clip
AAA
AAA
AAA
The detector tip lights up to
show a voltage is present.
2
3 Battery compartment
AAA
AAA
AAA
AAA
3
AAA
AAA

Publicité

Table des Matières
loading

Table des Matières