stabo VOX xm 3006e 12/24 V Manuel D'utilisation page 19

6) EMERGENCY CHANNELS ~ EMERGENCY CHANNEL SETTING
EMERGENCY CHANNELS
Emergency channels will be automatically selected by pressing the EMG key (8). First press:
emergency channel 1 is activated. Second press: emergency channel 2 is activated. Third press:
return to the current channel.
"EMG" appears on the display when an emergency channel is activated.
The default emergency channels are channel 9/AM (1) and channel 19/AM (2).
Note: Activating a emergency channel prevents changing the modulation mode (AM / FM /
UK) or enable/disable the VOX function. If the KEY BEEP function is activated, an error beep
sounds (see § KEY BEEP page 20).
EMERGENCY CHANNEL SETTING
Emergency channels can be customized (modulation mode and channel).
1. Short press the EMG key (6) until activated the emergency channel to be modified.
2. Long press during one second the EMG key (6).
If necessary, use the MODE key ( 8) to change the modulation mode: AM, FM or FM UK
(
Turn th OTARY knob (4) the select the emergency channel
Press PTT switch (11) to store and exit. If the KEY BEEP function is activated, an long beep sounds
to confirm the success of the operation (see § KEY BEEP page 20).
If no key is pressed for 5 seconds, the unit automatically exits EMERGENCY CHANNEL without save.
F
(short press)
Allows to set/validate functions (see for example § VOX SETTING above). This key pressed alone
don't have any use.
See § FREQUENCY BAND SELECTION page 21.
MODE ~ ANL
MODE
(short press)
Press MODE key (8) to select the modulation mode: AM or FM. Selected mode is displayed on
LCD.
Your modulation mode has to correspond to the one of your correspondent.
- Frequency Modulation / FM: for nearby communications on a flat open field.
- Amplitude Modulation / AM: commu nication on a field with relief and obstacles at middle
distance (the most used).
In U
"UK" is displayed when the ENG frequency band is selected. When the CEPT frequency band is
selected, "UK" disappears from the display (see table on page 47).
ANL
(long press)
Automatic Noise Limiter. This filter allow reducing back ground noises and some reception inter-
ferences.
Long press the ANL key (8) to activate/disable the ANL filter. "ANL" appears on the display
when the filter is activated.
Note: ANL filter works only in AM mode
USB CHARGING SOCKET
The USB socket (9) can be used to charge smartphones, tablets or other rechargeable devices
with 5 V - 2.1 A.
6 PIN MICROPHONE PLUG
The plug is located on the front panel of the transceiver and makes the setting of the equipment
into the dashboard easier.
See Cabling Diagram page
(short press)
only: The MODE key (8) allows to select the ENG or CEPT frequency band.
.
appears on the display, "EMG" blinks.