Installation; I Assembly; Assembly Of Built-In Gas Hob - Pelgrim GKV 102-107 Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation

General
The fitting of the appliance should only be
carried out by a registered Corgi gas fitter.
Please note:
The type of gas and the country for which the
appliance has been designed are indicated on
the ratings plate.
This is a category 3 appliance.
Gasconnection RC1/2" (ISO 7/1-RC1/2)
I
The gas connection must comply with
national and local regulations.
We recommend that the hob be connected
by means of a fixed pipe. Connection using
a specially designed safety hose is also
permitted.
Behind an oven use must be made of a pipe
made entirely out of metal.
Please note:
A safety hose may not be bent and must not
come into contact with moving parts of
kitchen units.
In all cases the connection tap for the
appliance must be positioned such that it is
easily accessible.
Before using the appliance for the first time
check the connections using water and
washing-up liquid to ensure that there are no
gas leaks.
Please note:
The bottom of the hob becomes hot.
Electrical connection (solely for appliances
with a spark switch)
230 V - 50 Hz – 0.6 VA
The electrical connection must comply with
national and local regulations. Wall socket
and plug must be accessible at all times. If
you want to make a fixed connection, ensure
that a multi-pole switch with a distance
between contacts of 3 mm is installed in the
supply cable.
Please note:
This appliance must be earthed. If the
connecting cable is damaged, it may only be
replaced by the manufacturer, the
manufacturer's service organisation or
equivalently qualified persons, in order to
avoid dangerous situations.

Assembly of built-in gas hob

Please note:
Do not install a hob next to a high cupboard or
wall made of flammable material. (If there is
no alternative, ensure that there is a minimal
distance of 40 mm between the outer edge of
the hob and the wall in question. Also ensure
that there is a minimum distance of 65 cm
between the hob and any overhead extractor
fan which may be installed).

Publicité

Table des Matières
loading

Table des Matières