Ramiaudio CSS404 Manuel Utilisateur page 30

F/ Input channels configuration.
1. Blank Threshold Filter.
The value "Blanlk Threshold" sets the level when the signal is considered as missing. Threshold varies from -60 to 0dBFs,
step 1 dB for a digital configuration, and from -45 to +15dBu, step 1 dB for an analog configuration . When enabled
this filter outputs an audio type alarm.
This filter computes RMS level instead of PEAK level.
2. Alarm Delay
This parameter sets the time from the error detection to the "ALARM" on CSS404.
Obviously if the error disappears during that time, the CSS 404 will not got to "ALARM".
IMPORTANT:
This delay is used only with audio filters. Using filters "AES error", CSS404 switches immediately to back up audio
signal .
3. Reset Delay

These value set the time between error disappearance and CSS404 alarm cancellation, and return to the main source.
Should an other error occur during this time CSS404 stay on "ALARM "
IMPORTANT:
This delay is used only with audio filters. Using filters "AES error", CSS404 switches immediately to back up audio
signal .
RAMI
WEB INTERFACE - next -
Parameter Check box
Blank Threshold Enable/disable
Parameter Value
Alarm delay
1 ~ 180
Parameter Value
Reset delay
1 ~ 180
To save the configurations
Value
Comment
0 ~ -60
threshold in dBFs or dBu
Comment
Delay (second)
Comment
Delay (second)
30 CSS404