Installation Guide - Ramiaudio CSS404 Manuel Utilisateur

It is good practice to connect all equipments before to switch on.
A/ Wiring :
 The first time, connect CSS404 to your computer using RJ45 port (LAN on the rear panel) Use a crossed
wire.
Attention sometimes it is necessary to use a crossed wired with old net cards.
B/ Starting :
 Stand alone :
CSS404 features a web server allowing control from you favorite web browser. Open your browser, enter CSS IP
address into the address window. Default factory IP address is 192.168.0.40
http:// 192.168.0.40
You can now access Web pages, to configure the equipment, which network settings. For the connection to the
device, an authentification is required for security measures.
Attention, in case of difficulties, follows the procedure in "technical tools"» annex.
 Use on a net :
Connect CSS404 to the net using the RJ45 connector. To work properly the CSS IP address should be unique on the
network, and in the available IP range. Should the PC or routeur net differ from CSS404, first modify PC or routeur
to the same net as CSS404, then set CSS IP address as described in "technical tools" annex.
RAMI

INSTALLATION GUIDE

Made in France
OUT
(Fr)
MAIN BACKUP
90 to 270V 12W / T 1AL 90 to 270V 12W / T 1AL POWER FAIL/RELAY OUT
MAIN BACKUP MAIN
PUSH PUSH
LAN
BACKUP RS232 AES/EBU OUT AES/EBU IN
RJ45
27
R L R L R L
PUSH PUSH PUSH PUSH
ANALOG OUT BACKUP ANALOG IN MAIN ANALOG IN
RJ45
Authentification Pop-up. The factory
configuration is:
-User: admin
- Password: admin
CSS404