emerio SDR-126618 Mode D'emploi page 7

SDR-126618
PREPARATION BEFORE THE FIRST USE
1. Remove all packaging material including the foam base and foam tape for accessories fixing.
2. Clean the appliance according to section "Cleaning and maintenance".
3. Do not plug in after the appliance is placed flat and cleaned. Let the appliance stand for more than 2 hours,
then turn the power on to make sure the normal operation of the appliance is working.
4. Plug in the appliance for trial operation. Do not put food in the appliance. Let it run without load.
Open the door after 1 hour and feel the temperature inside the appliance. If there is an obvious cooling
feeling inside, it means the appliance is working normally. Put food in the appliance.
Attention:

The appliance needs to be placed on a flat surface. If it needs to be high, please choose a stable, hard, non-
flammable pad. Do not use the packaging foam of the appliance to pad the height.

Do not put the appliance in damp and splashy places. The splashed water and dirt should be cleaned in time
to prevent rust and bad influence on the performance of the electrical insulation.

Do not put the appliance in too cold environment, and do not use it outdoors or in rain.

The appliance should be placed away from heat sources and avoid direct sunlight, so as not to affect its
performance.

The appliance should be placed in a well-ventilated location. There should be more than 10cm space around
the appliance including the back.

Small daily articles can be placed on the top of the box, not heating appliances.
PARTS DESCRIPTION
1. Wireless charging symbol
2. Control panel
3. USB ports
4. Sliding tray
5. Drawer
6. Feet
7. Password box
Note: this combination of drawer, sliding tray and password box results in the most efficient use of energy for
this refrigerating appliance.
- 6 -
EN