Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. Press
to switch on the handset.
3. Hold the handset within 150-300 mm (6-12") of the energizer and press
will stop pulsing (may take up to 2 seconds) and only the large, green light on the right will
continue flashing.
4. Press
to switch off the handset.
Change the energizer's address setting
1. Press and hold
2. Press and hold
3. Select the Address (Ad) option, and press
setting.
4. Hold the handset within 150-300 mm (6-12") of the energizer then press
the new setting to the energizer.
A moving arrow on the handset's screen indicates that the command is being sent to
the energizer. The large, red light on the left illuminates for 6 seconds as the energizer
receives the command. The energizer then resumes in Standby mode with only the large,
green light on the right flashing. After a few seconds, the handset will automatically switch
itself off.
To exit the Set-up mode without changing the energizer's address:
• Instead of pressing
off the handset without transmitting the new setting.
Test whether the energizer is obeying commands from the handset
1. Press
to turn on the handset and move to within 150-300 mm (6-12") of the energizer.
2. Press
or
Tip: Make a note of the energizer's address setting to save time should the address be acci-
dentally changed, or if an additional remote control is required in the future.
Measuring the voltage on a fence line
1. Press
to turn on the handset.
2. Insert the fence wire into the Fault finder slot, ensuring that the fence wire touches the Fault
finder contact.
3. After a few seconds, the voltage is displayed in the top, right-hand corner of the display (in
kilo volts).
Note: During the first few seconds, the handset displays the last recorded current reading in
amperes before displaying the voltage reading.
Measuring the output voltage of an energizer
1. Press
to turn on the handset.
, then press
to enter the Set-up mode.
to scroll through the list of available options.
in step 4, which transmits the new setting, press
to turn the energizer on or off.
repeatedly to scroll to the desired address
- 21 -
. The energizer
to transmit
. This switches
Publicité
Table des Matières
