Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
gizer (an energizer that has not been set up to obey commands from a handset):
Activate the remote control function of a Remote Ready energizer
A Remote Ready energizer will not respond to commands sent by the handset until the remote
control function has been activated.
Before activating the energizer's remote control function:
• Switch off the power supply to the energizer and wait for 1 minute, then switch on the power
supply again.
Note: A Remote Ready energizer will only accept a new address within four minutes of the
power supply being switched on. The energizer must be on and must not be in Standby mode
before the remote control function can be activated.
To activate the function:
1. Press and hold
2. Press and hold
3. Select the address (Ad) option, and press
4. Hold the Remote Control Fence Compass within 150 to 300 mm (6 to 12") of the energizer
and press
to transmit the new setting to the energizer.
A moving arrow on the Handsets screen indicates that the command is being sent to
the energizer. The large, red light on the left illuminates for 6 seconds as the energizer
receives the command. The energizer then resumes in Standby mode with only the large,
green light on the right flashing.
To exit the Set-up mode without activating the energizer's remote control function:
• Instead of pressing
off the handset without transmitting the new setting.
Test whether the energizer is obeying commands from the handset
1. Press
to turn on the handset and move to within 150-300 mm (6-12") of the energizer.
2. Press
or
Tip:
Make a note of the address setting of the energizer to save time should the address be
accidentally changed or if an additional remote control is required in the future.
Changing an energizer's address setting
Follow these instructions to overcome close proximity interference (for example your neigh-
bour's energizer is receiving commands from your handset, or your own energizer is switching
to Standby mode or switching OFF for no particular reason):
Note: Before changing the energizer's address setting, the energizer must be in Standby mode.
Switch the energizer to Standby mode
1. Switch off the power supply to the energizer and wait for 1 minute, then switch on the
power supply again.
, then press
to enter the Set-up mode.
to scroll through the list of available options.
in step 4, which transmits the new setting, press
to turn the energizer on or off.
until the number you want is displayed.
- 20 -
. This switches
Publicité
Table des Matières
