Identification Plate; Recommendations For Installation; General Notes - Nordcap MZ Série Instructions De Montage

1 Reception
On receiving the equipment, check carefully that the packaging is intact and has not been damaged in transit.
After unpacking, check that you have all the components and if the characteristics correspond to those on the order
form.
Installation, maintenance and other work should be carried out by specialised and authorised technicians. The
manufacturer accepts no responsibility and will not cover the guarantee if these conditions are not respected.
This appliance must be used according to these instructions and only for the manufacturer's purpose. The incorrect use of the
equipment can cause damages to the equipment and to users.
As a result of our constant effort to make technological improvements, the specifications indicated here are subject to change
without warning.
2

Identification Plate

Our models have a plate in the interior of the door panel, in the superior left edge on which the main data can be found. The
MODEL and SERIES are absolutely essential when consulting the manufacturer.
1
2
3
4
5
6
The crossed-out wheeled bin means that within the European Union the product must be taken to separate collection at
the product end-of life. This applies to your device but also to any enhancements marked with this symbol. Do not dispose
of these products as an unsorted municipal waste.

Recommendations for Installation

3 Recommendations for Installation

3.1 General Notes

Although the production of each appliance is rigorously controlled during manufacture, this does not exclude the possibility of
damage caused in transit. The general condition of the appliance should therefore be checked on arrival.
3.2 Placing
Remove the packaging carefully so that the equipment's surfaces are not damaged. Remove the PVC protection.
The appliance should be installed away from heat sources (ex: heating appliances) and direct sunlight.
To ensure that the appliance functions well, it should always be correctly levelled and slightly inclined to the back, to
make sure that the door closes perfectly. Small differences in level can be compensated for by regulating the feet.
3.3 Installation
The following standards should always be bared in mind during installation:
Regulations concerning the buildings, and anti-fire standards.
Rules concerning accident prevention.
European standards into effect.
MNS00009.03
TEC
Assembly Instructions
MODEL
CODE
SERIAL N.º/YEAR
CURRENT
VOLTAGE/FREQ.
POWER
Legend:
- Mode
- Code
- Series Number
- Doesn't apply
- Doesn't apply
- Doesn't apply
DOOR RESISTANCE
LIGHT POWER (MAX.)
DEFROST
COOLANT/QTY
TEMPERATURE CLASS
7 - Doesn't apply
8 - Doesn't apply
9 - Doesn't apply
10 - Doesn't apply
11 - Doesn't apply
12 - Doesn't apply
N.º
MNS00009.03
13/57