RocketFish RF-WHTIB Guide De L'utilisateur page 11

Notes:
For speaker wires that have proprietary connectors, you may strip the end of the
wires to allow connection to the receiver. However, check with the speaker
manufacturer before doing this, as it may void the warranty.
Make sure the exposed tips of each cord do not touch each other, and that they are
fully inserted into the terminals.
Connecting the receiver to an AC power outlet
To connect the receiver to an AC power outlet:
Open cover of the cable storage compartment on the bottom of receiver,
1
then unwrap the cable and extend it to the desired length.
Close the cover and make sure that the extended cable is not pinched
2
and comes out from the power cord hole as shown in the diagram.
Plug the AC power plug into a power outlet.
3
Plug the AC
power cord in
only after all
speakers are
connected to
the receiver.
Power cord hole
RF-WHTIB 11