Take the lid with the tea strainer. Remove the tea strainer and fill the tea strainer with loose
●
tea. When filling, observe the information on the tea packaging.
IMPORTANT!
The tea strainer should only be filled to approx. 2/3, as the dried tea leaves expand in the
water and the tea strainer could open as a result.
Press the filled tea strainer carefully onto the lid again.
●
At the handle of the lid, pull the tea strainer upward to the limit stop.
●
Put on the lid with the tea strainer.
●
Switch on the unit by touching the
●
Touch on the desired temperature.
●
Temperature selection
80 °C
70 °C
60 °C
1 beep will sound, with the LED ring illuminating blue.
IMPORTANT!
During the heating process, the temperatures can be changed as long as the requested tem-
peratures have not been reached yet.
IMPORTANT!
Make sure that the maximum fill mark is not exceeded. Fill the unit so that the water level is
between the minimum and the maximum fill-level marking. Burns / scalding may be caused
by effervescent water.
During the heat-up process the set temperature will be continuously flashing and the under-
●
lying temperatures will light up when being reached.
Once the desired temperature has been reached, 2 beeps will sound. The illuminated LED
●
ring will go out.
The unit will switch off after approx. 1 minute unless the warm-keeping function has been
●
selected.
Press the tea strainer downward and allow the tea to brew.
●
CAUTION
Do not bring the tea mixture to the boil, otherwise it may bubble over.
After the desired infusion time (information on the infusion time can be taken from the tea
●
26
symbol.
Ideal for:
all black teas, herbal and fruit tea mixtures
all green tea types and instant drinks, 80°C
green and white teas, 70°C
Japanese green tea, 60 °C