Further Settings - Harvia Xenio RGBW Instructions D'installation Et D'utilisation

Instructions for use for the user
5.5. Making colour light settings
Press the Menu button to open the settings menu
► Light group 1 flashes
► Make settings while the display is flashing
(approx.10 seconds)
Press the colour selection button and select:
● Use + or - to select red, yellow, green, cyan, blue, purple, white
(=factory setting colours) or
● Use the touch colour ring (colours of the factory setting are reprogrammed,
these colours are used for the colour changer)
► Display on the inside of the colour ring
Press the brightness button and select:
● Use + or - to select the intensity (40%, 50%, 60%.... 100%)
► Display of the intensity on the inside of the colour ring
Press the colour changer button and select:
● Use + or - to select the speed (2, 4, 6, 8, 10, 20, 30 seconds)
► Fast / slow flashing display of the selected light group
Press the Menu button to change the light group

5.6. Further settings

Deactivating an individual light group because no LED is connected:
● Press the Menu button until the desired light group flashes.
● Press the ON/OFF button, to switch off the light group.
► This light group is no longer displayed in operating mode
Resetting to factory settings:
● In operating mode, press the colour selection and brightness buttons simulta-
neously (although they are not illuminated) for approx. 3 seconds (long press).
► The light control switches off
p. 5/7