Product Description; Scope Of Delivery; Optional Accessories; Product Features - Harvia Xenio RGBW Instructions D'installation Et D'utilisation

Instructions for installation and use

3. Product description

3.1. Scope of delivery

● Xenio RGBW colour light control
● 5 m connection cable
● Assembly instructions

3.2. Optional accessories

● DMX CC driver (DMX-CC)
● DMX CV driver (DMX-CV)
● LED tubes RGBW (LED-TB-xx)
● LED spots RGBW (LED-SP-RGBW-xx)
● Power supply units (LED-PWS-xx / LED-150)

3.3. Product features

The Xenio RGBW colour light control has the following functions:
● Four independently operable colour light groups that can
be adjusted in terms of brightness, colour and speed of colour changer
● Colour selection via colour ring
● White for all light groups – dimmable in 7 steps

4. Installation and connection

The Xenio RGBW light controller is splash-protected and has a low operating
voltage. The light controller can be mounted inside the cabin if the following
points are observed:
● Install the device as far away from the sauna heater, infrared lamps or other
heat sources as possible.
● Do NOT install the device on or right next to the sauna heater or other heat
source.
● The maximum installation height in a sauna cabin is 100 cm. Surface mount-
ing is not recommended.
● The maximum installation height in an infrared cabin is 170 cm.
● No insulating material (such as mineral wool) may be located behind the device.
● Observe the ambient conditions (see 8. Technical data on page 7)
p. 2/7
EN