Maintenance And Storage; Daily Maintenance; Periodic Maintenance - BIG ASS FANS COOL-SPACE 200 Mode D'emploi

MAINTENANCE AND STORAGE

WARNING: ELECTRICAL SHOCK HAZARD. Disconnect the power supply
before performing service or maintenance. Failure to do so may result in
serious injury or death.
Removing the cooling media
Remove the cooling pads to access the inside of the cooler.
1. Remove pad grilles from support channel.
2. Tilt pads from the top and lift out of the cooler.

Daily maintenance

After each use, turn off the pump about 15 minutes before turning the fan off to
allow the pads to drain and dry out. This controls mildew and bacteria growth for a
long and efficient pad life. Drain the water from the cooler if it will be unused for a
prolonged period of time.

Periodic maintenance

The cooling pads act as a filter to remove dust and other particles from the
incoming air stream. The collected particles and any water impurities will flow into
the sump and collect there. To keep the cooler operating at peak efficiency, keep
the cooling media and sump clear of debris.
Draining the water sump
Depending on how often you operate the cooler, drain the sump anywhere from
every week for heavy use to monthly for light use.
1. Turn cooler off and disconnect the power supply.
2. Remove drain plug located at bottom of reservoir and let cooler drain.
3. Remove cooling pads.
4. Clean out reservoir with either a towel or wet/dry vacuum.
5. Reinstall pads and grille.
Using water treatment tablets
To avoid scale and mineral buildup, use water treatment tablets periodically. One
tablet is provided in the cooler's reservoir. Every 3 months, add 1 tablet to the
reservoir after cleaning. Additional tablets are available by calling 877-244-3267.
Cleaning the cooling media
Ensure the cooling pads are kept clean and dust-free. Dust and other particles
have an adverse effect on the pads' ability to introduce water into the air stream. If
the pad surface is dirty, clean with a soft brush and water. Never use bleach.
Storage
1. Remove cooling pads and clean with a soft brush and water to remove dust and debris.
2. Drain sump and wipe dry.
3. Store cooler in a dry area and cover to prevent dust buildup.
4
WWW.BIGASSFANS.COM © 2020 DELTA T LLC ALL RIGHTS RESERVED.