Cleaning Tips; Cleaning The Device - Wurth Master SEG 10 Traduction Des Instructions De Service D'origine

Cleaning methods
Normal soiling
‰ Spray and suction off detergent solution in one
work cycle.
Note
A repeated suctioning without spraying will shorten the
drying time.
Strong soiling or stains
‰ Apply detergent solution with suction turbine
turned off and soak for 10 to 15 minutes.
‰ Clean the surface just like with normal soiling.
‰ In order to further improve the cleaning result, the
surface can be recleaned using clear, warm water.

Cleaning tips

– Highly soiled spots should be presoaked and the
detergent solution should soak 5 to 10 minutes.
– Always work from the light to the shade (from the
window to the door).
– Always work from the cleaned to the uncleaned
surface.
– The more sensitive the surface (oriental rugs, ber-
bers, upholstery material) the lower the cleaning
solution concentration should be.
– Rugs with jute backing can shrink if too much water
is used and can bleed colours.
– Brush high-fiber rugs in the direction of the weave
after cleaning (using a fiber brush or a scrubber).
– Water-proofing the fabric using an approppri-
ate agent after the wet cleaning prevents a quick
resoiling of the textile surface.
– Do not step on cleaned surfaces until they have
dried and do not place furniture on them to avoid
pressure spots or rust stains.
– When cleaning previously shampooed carpets,
foam will be generated in the dirt water reservoir.
In such a case add an defoaming agent to the dirt
water reservoir.
Detergent
If you require further information please request the
product information sheet and the DIN safety data
sheet for the respective cleaning agent.
Shutting down
Empty the fresh water reservoir
‰ Switch off the spray and suction switches.
‰ Shortly activate the lever on bender to decrease
the pressure.
‰ Separate bender from the spray/suction hose.
Figure VII, see cover page
‰ Insert the suction hose into the fresh water reservoir.
‰ Press the suction switch to turn on the suction turbine.
‰ Empty the fresh water reservoir and switch the de-
vice off.
‰ Remove the lid.
Figure VIII, see cover page
‰ Remove the dirt water reservoir from the device
and empty it.

Cleaning the device

‰ Connect the bender (with suction pipe and nozzle)
to the suction hose.
‰ Connect the coupling of the fresh water hose to the
bender and lock into place.
Figure IX, see cover page
‰ Fill approx. 2 litres of fresh water into the fresh wa-
ter reservoir.
Do not add any detergents.
Figure X, see cover page
‰ Place nozzle into the dirt water reservoir.
‰ Press the spray switch to turn on the detergent
pump.
‰ Activate lever on bender and flush the device for
appr. 1 to 2 minutes.
‰ Turn off the device.
‰ Disconnect the mains plug from the socket.
Figure XI, see cover page
‰ Remove the dirt water reservoir from the device
and empty it.
‰ Clean the external surfaces of the device.
‰ Coil power cable around the carrying handle and
the lid.
13