Selecting The Nozzle - Wurth Master SEG 10 Traduction Des Instructions De Service D'origine

Dimensions and weights
Length
Width
Height
Weight without accessories
Hose diameter
Start-up
Figure I, see cover page
‰ Insert the holder for the floor nozzle (optional) into
the device and lock into place.
Figure II, see cover page
‰ Insert the suction hose into the suction hose con-
nection on the device.
‰ Insert the coupling of the fresh water hose into the
fresh water connection of the device and lock into
place.
‰ Connect the suction hose to bender of the manual
nozzle.
‰ Connect the coupling of the fresh water hose to the
bender and lock into place.

Selecting the nozzle

Upholstery, wall rugs,
automobile interior
cleaning
Carpeting
Stairs
* not included in the delivery
Operation
Figure III, see cover page
‰ Mix fresh water and detergent in a clean container (use
the concentration recommended for the detergent).
Warning
Health risk, risk of damage. Observe
all indications on the detergent used.
12
mm 575
mm 330
mm 445
kg 10
mm 32
Hand nozzle
Floor nozzle *
Carpet nozzle *
Note
Warm water (max. 50°C) will increase the cleaning
effect.
For considerate treatment of the environment use deter-
gent economically.
‰ Fill detergent solution into the fresh water reservoir.
The fill level must not exceed the "MAX" mark.
‰ Insert dirt water reservoir into the device and at-
tach lid.
‰ Insert the mains plug into the socket.
Figure IV, see cover page
‰ Press the suction switch to turn on the suction turbine.
‰ Press the spray switch to turn on the detergent pump.
Warning
Risk of damage. Check the object to be
cleaned prior to using the device in an
inconspicuous place for colour fastness
and water resistance.
Figure V, see cover page
‰ Use the lever on the bender to spray on detergent
solution.
‰ Run across the surface to be cleaned in overlap-
ping paths. Pull the nozzle backwards (do not
push).
Figure VI, see cover page
‰ During nozzle changes, the manual nozzle can be
inserted into the holder for the manual nozzle.
Empty the dirt water reservoir.
If the dirt water reservoir is full, switch off the suction
and spray switches.
‰ Remove the lid.
Figure VIII, see cover page
‰ Remove the dirt water reservoir from the device
and empty it.